Signal strength of clients via commandline

Post new topic   Reply to topic    DD-WRT Forum Index -> General Questions
View previous topic :: View next topic  
Author Message
0xff10
DD-WRT Novice


Joined: 09 Feb 2015
Posts: 2
PostPosted: Mon Feb 09, 2015 19:18    Post subject: Signal strength of clients via commandline Reply with quote
Hi,

the wireless information page shows me the signal strength and traffic usage of each client connected to my WIFI.

I've spent quite some time trying to figure out where this information is located, however, no luck so far.

Can this information also be accessed via the command line? If yes: How?

Thanks!
Back to top View user's profile Send private message
Sponsor
0xff10
DD-WRT Novice


Joined: 09 Feb 2015
Posts: 2
PostPosted: Mon Feb 23, 2015 13:29    Post subject: Reply with quote
I figured it out. My hardware is atheros-based, so:

Code:
wl_atheros -i ath0 rssi [mac-addr]


gives results like:

Code:
rssi is -69


Noise can be retrieved by

Code:
wl_atheros -i ath0 noise [mac-addr]
Back to top View user's profile Send private message
balabarath
DD-WRT Novice


Joined: 01 Dec 2014
Posts: 3
PostPosted: Fri Mar 27, 2015 9:24    Post subject: Reply with quote
The uptime can be retrived by

Code:
 wl_atheros -i ath0 uptime [MAC-address]

Like that is there any option to get tx and rx rate?
Back to top View user's profile Send private message
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Index -> General Questions All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You can attach files in this forum
You can download files in this forum