howto:general:network:switch_config
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
howto:general:network:switch_config [2016/03/08 14:12] admin |
howto:general:network:switch_config [2018/05/24 09:05] (current) |
||
|---|---|---|---|
| Line 17: | Line 17: | ||
| | | ||
| ===== Instructions ===== | ===== Instructions ===== | ||
| + | ---- | ||
| ==== GUI ==== | ==== GUI ==== | ||
| Line 28: | Line 28: | ||
| Per default, all ethernet ports are assigned to LAN, | Per default, all ethernet ports are assigned to LAN, | ||
| every attached device is part of the LAN-Network per default. | every attached device is part of the LAN-Network per default. | ||
| + | |||
| + | ---- | ||
| ==== Assign Switch port to WAN ==== | ==== Assign Switch port to WAN ==== | ||
| - | A need for configuring the switch ports may be, that you want to move a LAN Port, to the WAN port. | + | A need for configuring the switch ports may be, that you want to move a LAN Port, to the WAN-Network. |
| One might have a setup similar to: | One might have a setup similar to: | ||
| Line 42: | Line 44: | ||
| {{:howto:general:network:additional-wan-port.png?direct|}} | {{:howto:general:network:additional-wan-port.png?direct|}} | ||
| + | |||
| + | With this configuration, the PC1 will now receive an IP from the Modem or the DHCP Server in the WAN-Network, if the setup provides this | ||
| + | ---- | ||
| ===== Troubleshooting ===== | ===== Troubleshooting ===== | ||
howto/general/network/switch_config.1457446340.txt.gz ยท Last modified: 2018/05/24 09:05 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
