====== 8devices- Carambola 2 ====== ===== Support status ===== ^ Revision ^ FCC-ID ^ status ^ | - | - | supportted | ===== Hardware overview ===== | ^ CPU ^ Frequency ^ RAM ^ Flash ^ Ethernet ^ Wireless ^ USB ^ Serial ^ JTAG ^ ^ | Atheros AR9331 | 400 MHz | 16 MB | 64 MB | 2 x 100Base-T | b/g/n 150 Mbps | 1x 2.0 | via miniUSB | ? | ===== Installation instructions ===== ==== uboot - Bootloader ==== The bootprocess can be interrupted by pressing 'ESC' uboot commands: tftp 80060000 ddwrt-ar71xx-generic-carambola2-squashfs-sysupgrade.bin erase 9f050000 +${filesize} cp.b 80060000 9f050000 ${filesize} reset ===== Serial connection ===== A serial console is available on the external miniUSB connector: 115200 8N1, no hardware flow-control ===== Bootlog ===== ## Booting image at 9f050000 ... Image Name: MIPS OpenWrt Linux-3.18.11 Created: 2015-05-16 14:45:23 UTC Image Type: MIPS Linux Kernel Image (lzma compressed) Data Size: 11661548 Bytes = 11.1 MB Load Address: 80060000 Entry Point: 80060000 Verifying Checksum at 0x9f050040 ...OK Uncompressing Kernel Image ... OK Starting kernel ... [ 0.000000] Linux version 3.18.11 (markus@dd-workstation) (gcc version 4.8.3 (OpenWrt/Linaro GCC 4.8-2014.04 r45560) ) #2 Sat May 16 16:45:16 CEST 2015 [ 0.000000] bootconsole [early0] enabled [ 0.000000] CPU0 revision is: 00019374 (MIPS 24Kc) [ 0.000000] SoC: Atheros AR9330 rev 1 [ 0.000000] Determined physical RAM map: [ 0.000000] memory: 04000000 @ 00000000 (usable) [ 0.000000] Initrd not found or empty - disabling initrd [ 0.000000] Zone ranges: [ 0.000000] Normal [mem 0x00000000-0x03ffffff] [ 0.000000] Movable zone start for each node [ 0.000000] Early memory node ranges [ 0.000000] node 0: [mem 0x00000000-0x03ffffff] [ 0.000000] Initmem setup node 0 [mem 0x00000000-0x03ffffff] [ 0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes. [ 0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes [ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256 [ 0.000000] Kernel command line: board=CARAMBOLA2 mtdparts=spi0.0:256k(u-boot)ro,64k(u-boot-env)ro,16000k(firmware),64k(art)ro console=ttyATH0,115200 rootfstype=squashfs,jffs2 noinitrd [ 0.000000] PID hash table entries: 256 (order: -2, 1024 bytes) [ 0.000000] Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) [ 0.000000] Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) [ 0.000000] Writing ErrCtl register=00000000 [ 0.000000] Readback ErrCtl register=00000000 [ 0.000000] Memory: 50832K/65536K available (2487K kernel code, 123K rwdata, 528K rodata, 10356K init, 188K bss, 14704K reserved) [ 0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 [ 0.000000] NR_IRQS:51 [ 0.000000] Clocks: CPU:400.000MHz, DDR:400.000MHz, AHB:200.000MHz, Ref:40.000MHz [ 0.000000] Calibrating delay loop... 265.42 BogoMIPS (lpj=1327104) [ 0.080000] pid_max: default: 32768 minimum: 301 [ 0.080000] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.090000] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.100000] NET: Registered protocol family 16 [ 0.100000] MIPS: machine is 8devices Carambola2 board [ 0.600000] Switched to clocksource MIPS [ 0.600000] NET: Registered protocol family 2 [ 0.610000] TCP established hash table entries: 1024 (order: 0, 4096 bytes) [ 0.610000] TCP bind hash table entries: 1024 (order: 0, 4096 bytes) [ 0.610000] TCP: Hash tables configured (established 1024 bind 1024) [ 0.620000] TCP: reno registered [ 0.620000] UDP hash table entries: 256 (order: 0, 4096 bytes) [ 0.630000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) [ 0.640000] NET: Registered protocol family 1 [ 17.760000] futex hash table entries: 256 (order: -1, 3072 bytes) [ 17.770000] squashfs: version 4.0 (2009/01/31) Phillip Lougher [ 17.770000] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. [ 17.790000] msgmni has been set to 99 [ 17.800000] io scheduler noop registered [ 17.800000] io scheduler deadline registered (default) [ 17.800000] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled [ 17.810000] ar933x-uart: ttyATH0 at MMIO 0x18020000 (irq = 11, base_baud = 2500000) is a AR933X UART [ 17.820000] console [ttyATH0] enabled [ 17.820000] console [ttyATH0] enabled [ 17.830000] bootconsole [early0] disabled [ 17.830000] bootconsole [early0] disabled [ 17.840000] m25p80 spi0.0: found w25q128, expected m25p80 [ 17.840000] m25p80 spi0.0: w25q128 (16384 Kbytes) [ 17.850000] 4 cmdlinepart partitions found on MTD device spi0.0 [ 17.850000] Creating 4 MTD partitions on "spi0.0": [ 17.860000] 0x000000000000-0x000000040000 : "u-boot" [ 17.860000] 0x000000040000-0x000000050000 : "u-boot-env" [ 17.870000] 0x000000050000-0x000000ff0000 : "firmware" [ 17.910000] 2 uimage-fw partitions found on MTD device firmware [ 17.920000] 0x000000050000-0x000000fa0000 : "kernel" [ 17.920000] 0x000000fa0000-0x000000ff0000 : "rootfs" [ 17.930000] mtd: device 4 (rootfs) set to be root filesystem [ 17.930000] mtdsplit: no squashfs found in "rootfs" [ 17.940000] mtdsplit: no squashfs found in "spi0.0" [ 17.940000] 0x000000ff0000-0x000001000000 : "art" [ 17.960000] libphy: ag71xx_mdio: probed [ 18.560000] ag71xx-mdio.1: Found an AR7240/AR9330 built-in switch [ 18.590000] eth0: Atheros AG71xx at 0xba000000, irq 5, mode:GMII [ 19.180000] ag71xx ag71xx.0: connected to PHY at ag71xx-mdio.1:04 [uid=004dd041, driver=Generic PHY] [ 19.190000] eth1: Atheros AG71xx at 0xb9000000, irq 4, mode:MII [ 19.190000] TCP: cubic registered [ 19.190000] NET: Registered protocol family 17 [ 19.200000] bridge: automatic filtering via arp/ip/ip6tables has been deprecated. Update your scripts to load br_netfilter if you need this. [ 19.210000] 8021q: 802.1Q VLAN Support v1.8 [ 19.300000] Freeing unused kernel memory: 10356K (80373000 - 80d90000) [ 19.320000] init: failed to symlink /tmp -> /var [ 19.320000] init: Console is alive [ 19.330000] init: - watchdog - [ 19.370000] usbcore: registered new interface driver usbfs [ 19.370000] usbcore: registered new interface driver hub [ 19.380000] usbcore: registered new device driver usb [ 19.430000] SCSI subsystem initialized [ 19.440000] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver [ 19.450000] ehci-platform: EHCI generic platform driver [ 19.450000] ehci-platform ehci-platform: EHCI Host Controller [ 19.460000] ehci-platform ehci-platform: new USB bus registered, assigned bus number 1 [ 19.470000] ehci-platform ehci-platform: irq 3, io mem 0x1b000000 [ 19.500000] ehci-platform ehci-platform: USB 2.0 started, EHCI 1.00 [ 19.500000] hub 1-0:1.0: USB hub found [ 19.500000] hub 1-0:1.0: 1 port detected [ 19.510000] usbcore: registered new interface driver usb-storage [ 20.330000] init: - preinit - [ 20.640000] procd: - early - [ 20.640000] procd: - watchdog - [ 21.220000] procd: - ubus - [ 22.220000] random: ubusd urandom read with 34 bits of entropy available [ 22.240000] procd: - init - Please press Enter to activate this console. BusyBox v1.23.2 (2015-05-16 16:41:05 CEST) built-in shell (ash) ____ ____ _ _ _ _____ _____ _____ __ __ _____ | \| \ __| | | | __ |_ _| | | | | |_ _| | | | | |__| | | | -| | | | | | |> < | | |____/|____/ |_____|__|__| |_| |_|___|__|__| |_| ---------------------------------------------------- Made by embeDD GmbH (Bleeding Edge, r45560) ---------------------------------------------------- root@dd-wrt-nxt:/#