This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
documentation:general:vpn:vpn_service_provider [2015/12/17 10:30] admin [Privateinternetaccess] |
documentation:general:vpn:vpn_service_provider [2018/05/24 09:05] (current) |
||
---|---|---|---|
Line 43: | Line 43: | ||
- Choose device-type 'TUN' | - Choose device-type 'TUN' | ||
- | {{:documentation:general:vpn:openvpn-upload-config.png?direct|}} | + | {{:documentation:general:vpn:openvpn-enabled.png?600|}} |
+ | {{:documentation:general:vpn:openvpn-certificates.png?600|}} | ||
==== Create authentication file ==== | ==== Create authentication file ==== | ||
- | 1) enable SSHd | + | For using an authentication file change the Operation Mode to 'Use Custom Configutation File'. |
- | {{:documentation:general:vpn:dropbear-enable-ssh.png?direct|}} | + | Create an Empty text-file on your Computer with an Editor of Choice(e.g. Notepad) |
+ | * this must not be an .docx, .rtf or other binary format file, but a plain text-file | ||
+ | |||
+ | The first line of the created file, should contain the Username, for your VPN access | ||
+ | |||
+ | The second line should contain the according password for the VPN access | ||
+ | |||
+ | Save and Close the file, then copy the text-file to the router as for [[:ssh_and_scp|SSH and SCP]] to the router at the location "/etc/vpnuserpass.conf" | ||
- | 2) edit authentication file | ||
===== Pre-Configs ===== | ===== Pre-Configs ===== | ||
Line 187: | Line 194: | ||
tls-client | tls-client | ||
remote-cert-tls server | remote-cert-tls server | ||
- | daemon | ||
<ca> | <ca> | ||
-----BEGIN CERTIFICATE----- | -----BEGIN CERTIFICATE----- |