This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
howto:general:network:switch_config [2016/03/08 14:12] admin |
howto:general:network:switch_config [2018/05/24 09:05] (current) |
||
---|---|---|---|
Line 17: | Line 17: | ||
| | ||
===== Instructions ===== | ===== Instructions ===== | ||
+ | ---- | ||
==== GUI ==== | ==== GUI ==== | ||
Line 28: | Line 28: | ||
Per default, all ethernet ports are assigned to LAN, | Per default, all ethernet ports are assigned to LAN, | ||
every attached device is part of the LAN-Network per default. | every attached device is part of the LAN-Network per default. | ||
+ | |||
+ | ---- | ||
==== Assign Switch port to WAN ==== | ==== Assign Switch port to WAN ==== | ||
- | A need for configuring the switch ports may be, that you want to move a LAN Port, to the WAN port. | + | A need for configuring the switch ports may be, that you want to move a LAN Port, to the WAN-Network. |
One might have a setup similar to: | One might have a setup similar to: | ||
Line 42: | Line 44: | ||
{{:howto:general:network:additional-wan-port.png?direct|}} | {{:howto:general:network:additional-wan-port.png?direct|}} | ||
+ | |||
+ | With this configuration, the PC1 will now receive an IP from the Modem or the DHCP Server in the WAN-Network, if the setup provides this | ||
+ | ---- | ||
===== Troubleshooting ===== | ===== Troubleshooting ===== |