This shows you the differences between two versions of the page.
howto:general:service:wake_on_lan [2017/02/28 15:34] admin |
howto:general:service:wake_on_lan [2018/05/24 09:05] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Wake on LAN ====== | ||
- | Wake-on-LAN is an ethernet protocol for waking computers up from a very low power mode remotely. This was created by AMD in collaboration with Hewlett-Packard. | ||
- | |||
- | ===== GUI ===== | ||
- | |||
- | 1. Open your router's configurations website and login (default: 192.168.11.1) | ||
- | |||
- | 2. Go to Network Services --> Wake on LAN | ||
- | |||
- | 3. Add a new entry with the [+] Button | ||
- | |||
- | 4. Enter a Device Name (only for managing entries) | ||
- | |||
- | 5. Enter the MAC Address of the device you want to wake up | ||
- | |||
- | 6. If needed: enter the password from your target / check the box to wake up the target on boot | ||
- | |||
- | |||
- | {{ :howto:general:wireless:wol1.png?nolink&800 |}} | ||
- | |||
- | Make sure you have enabled wake on lan on your target! Mostly you will find this option in the bios under 'Power'. |