✎ howto:use_cases:wireless:guest_ap [DD-WRT NXT Wiki]

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Guest AP ======

A 'wireless guest ap' basically is just an VAP (__V__irtual __A__ccess-__P__oint) running on the same physically wireless interface as the normal access-point.
However the VAP can have its own SSID with its own encryption settings which differs form the main wlan.

Running the guest instance as a virtual interface, makes it possible to separate it completeley from the private part of the network.

===== Overview =====

==== Level of difficulty ===

   Medium

==== Use-case ===

It is quiet nice to let friends and other visitors use your wireless network to give them access to the internet. But offering the private wireless password, even to close friends, isn't a preferrable option.

These instructions shows how to setup an independent guest-network with the following properties:

^ wireless guest access ^^
|SSID: | guest-wlan |
|Passphrase: | guest-access |
|Encryption: | WPA2-PSK (AES) |
|Network: | 192.168.101.1 |
|DHCP: | yes |
|DHCP range: | 62 - 100 |
|Internet: | yes |

==== Related topics ====

Aarticles:
  * [[howto:general:dhcp:multiple_dhcp|Multiple DHCP-Server instances]] \\ 
  * [[howto:general:virtual_ap|Multiple virtual ap's]] \\ 

Config-files:
  * [[documentation:configuration:config_files:config_network|/etc/config/network]] \\ 
  * [[documentation:configuration:config_files:config_wireless|/etc/config/wireless]] \\ 
  * [[documentation:configuration:config_files:config_dhcp|/etc/config/dhcp]] \\ 
  * [[documentation:configuration:config_files:config_firewall|/etc/config/firewall]] \\ 

===== Instructions =====

==== GUI ====

In this tutorial we will configure step-by-step the guest access point.

At first open your browser and go to your router's configurations website (default: 192.168.11.1). Log in to the router with your password.

Go to the __Network Settings__ tab and then to __Wireless__.
 
{{ :howto:use_cases:wireless:nxtgui_guestap1.png?nolink&800 |}}

In the under right corner of every radio you will notice a button [+] which creates a new virtual access point. After creating the access point a SSID is required. To edit the existing one click on the pencil next to the name of the access point of your choice.

{{ :howto:use_cases:wireless:nxtgui_guestap2.png?nolink&800 |}}

After choosing or creating your access point you must open the __Advanced__ section underneath the encryption settings. Now you must select __Bridge to__ **GUEST_LAN** and now it's separated from the other LANs.
 
===== Troubleshooting =====

   Not available, yet
Page Tools
