Linksys EA6300
From DD-WRT Wiki
NOTE: EA6300V1 hardware with an FCC/IC ID suffix of EA6400 is identical to the EA6400: see Linksys EA6400.
This guide covers these very similar models: EA6200, EA6300 (with EA6300 ID), EA6350v1, & EA6350v2.
These use linksys-ea6350/ firmware, but the EA6350v2 requires serial flash. Reference: Supported Devices wiki.
[edit] Hardware Specifications
CPU | Broadcom BCM47081A0 | 800 MHz |
---|---|---|
Flash ROM | Spansion S34ML01G100TF100 | 128 MB |
RAM | Hynix H5PS1G63JFR-S6C | 128 MB |
NVRAM | 60KB | |
2.4 Ghz Radio | Broadcom BCM43217 2x2 802.11b/g/n | IEEE 802.11b (up to 11Mb/s)
g (up to 54Mb/s)/n (up to 300 Mb/s) |
5 Ghz Radio | Broadcom BCM4352 2x2 802.11a/b/g/n/ac
& two 5 GHz amplifiers | IEEE 802.11a(up to 54Mb/s)
n (up to 300 Mb/s) |
Antenna Location | Internal | 3 |
Switch | BCM47081A0 (Gigabit) | 4x GbE + 1 WAN |
USB | 1x | USB 3.0 |
[edit] Installation
Read the Firmware FAQ: download links are in the Where do I download firmware? section
EA6300V1 hardware with an FCC/IC ID suffix of EA6400 is identical to the EA6400, but uses linksys-ea6300 firmware.
- For an FCC/IC ID suffix of EA6400, see the Linksys EA6400 wiki.
The following hardware uses linksys-ea6350 firmware: see this EA6350 forum thread.
- EA6300 hardware (no labeled version) with an FCC/IC ID suffix of EA6300
- EA6200
- EA6350v1
- EA6350v2: this requires serial flash with these instructions