Linksys WRT54GS v2.0
From DD-WRT Wiki
Contents |
WRT54GS v2.0 Specs
- Chipset: BCM4712
- Ram: 32 MB
- Flash: 8 MB
How To Flash
Read the Firmware FAQ and Broadcom forum build threads before upgrading!
- Use GUI or TFTP flash with a wired connection. Disable wireless to be safe.
- DO NOT 30/30/30 HARD RESET this model as this could brick your router. See the Peacock Announcement Note 1.
Initial Flash
Download Build 14929 dd-wrt.v24_mini_wrt54gs.bin
- Reset by keeping the router powered on and holding the reset button until the lights flash (up to 30sec)
- Open 192.168.1.1 in a web browser (if issues are encountered, try another browser)
- User = (Leave Blank)
- Password = admin
- If this does not work, see the above reset info to restore to factory defaults.
- Check the firmware version in the top right corner to be 4.71.4, otherwise flash:
- WRT54GS_4.71.4.001_fw.2.bin (factory firmware was removed by Linksys)
- DO NOT flash this to a WRT54GSv1
- Go to Administration -> Factory Defaults -> Restore -> Apply Settings to flash dd-wrt.v24_mini_wrt54gs.bin
- Wait 5 minutes for the router to reboot
- If no response, unplug the router for 10 seconds then plug it back in
- Access the GUI to set a password
Upgrade Flash
- Go to Administration -> Firmware Upgrade to select the file to Upgrade
- Wait 5 minutes for the router to reboot (power cycle if needed) then reset
- Access the GUI to set a password and configure