Alfa N5
From DD-WRT Wiki
Contents |
= Planet WNAP-7320 = OTAi 724S
This instruction is also valid for the Alfa N5c
[edit] Hardware
- CPU Atheros AR7240
- Flash 8MB
- RAM 32 MB
[edit] Serial Port
115000,1,n,8
1 PWR 2 TX 3 RX 4 GND
[edit] Flashing
[edit] Initial
For initial flashing you have to access the device via serial connection.
Firmware files can be found here: Where do I download firmware?
[edit] U-Boot
Since the default is set to boot from the fixed address 0x9f650000, an new bootloader must be flashed before you can boot DD-WRT. You will have to setup an tftp server where you can download the files. When the cli asks type 1 to enter the command line. print the envsettings and set the ip and server address. Process each line step by step from the uboot console:
tftpboot 0x80060000 uboot.bin erase 9f000000 +$filesize cp.b $fileaddr 0x9f000000 $filesize
when the download doesnt work, try again with the 2nd eth port.
The new version will be U-Boot 1.1.4
Dont reset/reboot yet!
[edit] DD-WRT/Recovery
Afer the uboot is flashed go on installing DD-WRT from the cli:
tftp 0x80060000 firmware.bin erase 9f050000 +$filesize cp.b $fileaddr 0x9f050000 $filesize