Differences

This shows you the differences between two versions of the page.

--- howto:general:service:wake_on_lan [2017/02/28 13:04]
admin
+++ howto:general:service:wake_on_lan [2018/05/24 09:05] (current)
@@ Line 1: / Line 1: @@
 ====== Wake on LAN ======
-Wake-on-LAN is an ethernet protocol for waking computers up from a very low power mode remotely. This
+Wake-on-LAN is an ethernet protocol for waking computers up from a very low power mode remotely. This was created by AMD in collaboration with Hewlett-Packard.
 ===== GUI =====
-In this tutorial we will setup Wake on LAN.
+. Open your router's configurations website and login (default: 192.168.11.1)
-At first open your browser and go to your router's configurations website (default: 192.168.11.1). Log in with your password.
+. Go to Network Services --> Wake on LAN
-Go to the __Network Serices__ tab and then to __Wake on LAN__.
+. Add a new entry with the [+] Button
-{{ :howto:general:wireless:wol1.png?nolink&900 |}}
+. Enter a Device Name (only for managing entries)
-Add a new entry with the [+] Button. After that you are able to enter device name (only for managing entries), MAC address and if needed password of your machine.
+. Enter the MAC Address of the device you want to wake up
+. If needed: enter the password from your target / check the box to wake up the target on boot
+{{ :howto:general:wireless:wol2.png?direct |}}
+Make sure you have enabled wake on lan on your target! Mostly you will find this option in the bios under 'Power'.